全部新闻 当前位置:网站首页>行业资讯 > 正文
  • 不锈钢储罐冬天如何防冻?
  • 本站编辑:杭州萧山升达防腐设备厂发布日期:2017.12.05

      最近几天,受冷空气影响,北方各地,瑞雪飘飘,广州温度也下降到12°-13°了。冬天严寒环境的到来,恒东不锈钢储罐厂家提醒各位客户要注意防寒保暖。在我们防寒保暖的同时,我们的不锈钢储罐也需要注意防寒保温,预防在低温环境下,罐内管道液体冻住,影响工作效率,损坏不锈钢储罐设备。

      In recent days, affected by cold air, around the north, Guangzhou snow fluttering, the temperature dropped to 12 degrees -13 degrees. The arrival of the winter cold environment, Hengdong stainless steel tank manufacturers to remind customers to keep warm. While we are cold and warm, our stainless steel storage tanks also need to pay attention to cold prevention and heat preservation, so as to prevent liquid pipes from freezing under the low temperature environment, affecting the working efficiency and damaging the stainless steel storage tanks.

不锈钢储罐特别是卧式储罐,由于其占地面积较大,一般是安装在户外使用,冬天的到来,特别是储罐安装在北面或者迎风的客户,就更要注意给不锈钢储罐防寒保温了。不锈钢储罐防寒保温可选用石棉、生棉、棉絮、厚衣裳等包住,然后再包上一层防水塑料布等防水材料来防寒保温。
Stainless steel storage tanks, especially horizontal tanks, are usually installed for outdoor use because of their large area. The arrival of winter, especially the customers installed on the north side or facing the wind, should pay more attention to the cold storage and insulation of stainless steel tanks. Stainless steel tank thermal insulation can be used asbestos, raw cotton, cotton, thick clothes wrap, and then covered with a layer of waterproof plastic cloth, waterproof material to cold insulation.
 
如果不锈钢储罐的管道、出口被冻住了,切记不可用暴力敲打罐体管道消融,可以用电吹风来回烘吹,或用毛巾包裹后慢慢用温水浇淋,用锤子轻轻的击打水管,直到冰冻消融。在消融过程中,不可直接用开水浇淋,冷热交替易引起管道爆裂。在防冻、消融过程中,客户需要针对自己物料的特性选择适合自己的防冻方法、消融方法,防止在防冻、消融过程引起不可预料的意外。
If the stainless steel storage tank's pipeline and outlet are frozen, it is not possible to crack the tank body by violence. It can be dried and dried by electric drier or wrapped with towel, then slowly poured in warm water and hammered gently to the water pipe until it freezes. In the process of ablation, it can not be poured directly with boiling water, and the alternation of cold and heat can easily cause the pipe burst. In the process of antifreeze and ablation, customers need to choose their own antifreeze methods and ablation methods according to their material characteristics, so as to prevent unforeseen accidents during freezing and melting process.